Earring log

Quick note for myself: the standard bar you are pierced with in the earlobe has 1.2mm thickness. I now have a ring with a 1.0mm thickness and 8mm diameter, made of surgical steel. If I want to go back to 1.2mm later for whatever reason, this is possible but I will have to go back to the piercer to stretch the lobe a bit in order to get new jewelry in.

In American terms, thickness is typically expressed in terms of the "gauge", where a higher gauge is thinner. This comes from electrical wiring, where a thinner wire has more electrical resistance... Notice the steps in mm are not equal size.

  • 0.8 mm is 21 gauge
  • 0.9 mm is 20 gauge
  • 1.0 mm is 19 gauge
  • 1.2mm is 18 gauge.

From what I understand, 1.2mm is a typical thickness for piercings, but for jewelry you'll often also find 1.0mm or 0.8mm.

Later I want to maybe try a smaller ring of 7mm, but the piercer recommended 8mm for now because if the ring touches your earlobe and you lay on it, it will be under pressure.

As a backup for the ring (and in case I turn out to be sensitive for the nickel in surgical steel), I maybe want to get a titanium labret piercing of 1mm. But how long? TODO: what's the length in mm of the labret I was pierced with?